Aqara T1 Recessed Housing
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a 3D-printed housing that converts a standard Aqara T1 door sensor into a fully recessed, invisible door sensor.
- Rating
- 5 / 5
- Likes
- 383
- Downloads
- 1,772
- Makes
- 9
- Views
- 12,162
- Reviews
- 10
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution — Noncommercial
Designed to fit inside a 20 mm hole drilled into a wooden door, with a matching recessed magnet in the door frame. Once installed, the sensor is completely hidden while retaining the reliability, battery life, and Zigbee support of the original Aqara hardware.
For some reason, nobody makes an affordable off the shelf recessed door sensor, so here we are!
Features:
Fully concealed installation
Uses the original Aqara PCB and magnet
Bind button remains accessible
Easy battery replacement
Inspired by commercial recessed sensors — at a fraction of the cost
Hardware required
1 x Aqara T1 door sensor
2 x M2x8mm
2 x wood screws for installation
👉 You’ll need to disassemble your own Aqara T1 sensor — assembly instructions are covered in the tutorial video.
Printing Instructions
This is a very easy print! Just place each component flat side down on the print bed.
PLA or PETG will work fine!
The Prusa Satin sheet gives a nearly invisible finish on my door frames for the magnets, you could also paint them for a truly invisible finish