Capresso Coffee Grinder Model 595 Lid
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
The lid for my coffee grinder broke. I tried super gluing it, and that held for a while, but I dropped it, and it…
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 13
- Makes
- 0
- Views
- 190
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution
The lid for my coffee grinder broke. I tried super gluing it, and that held for a while, but I dropped it, and it broke again. So, I decided to print a new lid. I designed it in Tinkercad. I inspected it and reduced it in Meshmixer.
Print Settings
Printer Brand:
Ultimaker
Printer:
Ultimaker 2
Rafts:
Yes
Supports:
Yes
Resolution:
0.8
Infill:
gradual
Filament: Lulzbot pla black translucent sparkle
Notes:
I decided to print it curved side up so that side would be smoother, but it would be a little faster to print it upside down. There were a lot of supports to remove (auto-generated in Cura). I tried to print it in ABS, but I had problems with adhesion. I tried a second time with a higher bed temperature. That helped a little, but it still failed. So, I switched to PLA. I measured the opening to be 120 mm and I added a 4 mm lip, so the entire lid should be 128 mm wide. Mine print fits the grinder, but it's a little loose. It will stay on while grinding, but it might rotate a bit. It would fall off if I turned the machine over without holding it in place. It's close enough that I haven't reprinted, but if I did, I would scale up ever so slightly. I don't know if this is a design error, or a printing issue.
Category: Kitchen & Dining