Prusa CORE One L Chamber Heater

This is an advanced project. This was only designed and tested to work with my needs in mind. My typical designs are tested to ensure they should work for everyone. This is not one of them.

You’ll likely need to:

• Use Fusion 360 to modify the design to adjust offsets for clearances depending on your nozzle and material choice

• Change the cutout for the AL sheet as they all seem to be different size, none precisely cut.  My sheet was 11 - 13/16

• Know how tune your Filament Extrusion, Z offset, & Elephants foot compensation

• Able to drill some precise 3.2mm holes in an aluminum sheet. You could also use 3mm screws instead of rivets which would allow for more misalignment.

How this was printed

• 0.6 Nozzle E3D ObXiDian® 500 

• Siraya Tech Fibreheart ABS-CF Core Filament – Frame

• Prusa Orange PETG – Hex Grid

• Prusa Galaxy PETG – Controller Mount

• 12 x 12, 0.06 - 1.5 mm  Anodized Aluminum Sheet

• 11- Push Clips Rivets 3mm x 8mm

• 8 - Push Clips Rivets 3mm x 6.6mm

• Creality Chamber Heater

The controller box is from here, but it was too tight, would scrape up the screen like the OP did. So I had to print it again at 105% for the thickness and width, I used 1.5mm layer. Also the magnets were not strong enough, so I used some adhesive tape to mount.