Ruark MR1 Mk3 – 13° Angled Desktop Stands

Each stand consists of three parts:

• 1 × Top plate with oval port opening

• 2 × Runner-style base feet

The oval opening in the top plate ensures that the down-firing bass reflex port remains acoustically unobstructed.

The recessed pockets on the top surface are sized to fit the original rubber feet of the MR1 Mk3.

⚠ Compatibility

These stands are designed exclusively for the Ruark MR1 Mk3.

Please verify before printing:

If the measured distance between the speaker feet is

96 mm width (center-to-center)

and

131 mm depth (center-to-center)

then these stands are compatible.

They do not fit the MR1 Mk2.

Printing Recommendations

• No supports required

• Recommended material: PLA (matte finish works especially well visually)

• Layer height: 0.2 mm

• Infill: minimum 40 %

• 3–4 perimeters recommended for structural rigidity

Assembly

Per stand you will need:

• 4 × M3 heat-set inserts

• 4 × M3 countersunk screws (maximum 10 mm length)

The runners are attached from above, through the recessed foot pockets in the top plate.

The screw heads sit flush inside the foot recesses and are completely hidden once the speaker is placed on top.

Each runner includes two circular recesses for:

• Silicone anti-slip pads

• Diameter: 7.5 mm

These provide additional stability on smooth surfaces.

Design & Function

• Tilt angle: 13°

• Optimized for desktop / nearfield listening

• Bass reflex port remains acoustically free

• Three-part construction for clean assembly and strength

• Minimalist runner design

The upward tilt improves alignment with ear height and enhances imaging and spatial coherence in nearfield setups.

Why I Designed This

I created these stands because the Ruark MR1 Mk3 benefit noticeably from a slight upward tilt when used on a desk. While the speakers include well-designed factory feet, there is no official angled stand solution available.

In my setup, a 13° tilt improved tonal balance and stereo imaging, particularly at a listening distance of approximately one meter. I also wanted a design that:

• preserves the function of the down-firing port

• integrates perfectly with the original speaker feet

• maintains a clean and lightweight appearance

• can be printed without supports

• provides mechanical stability

The result is a subtle runner-style design that complements the aesthetic of the speakers while improving ergonomics and sound alignment.

Acoustic Considerations

The MR1 Mk3 features a down-firing bass reflex port. Blocking or restricting this opening can alter bass performance and reduce low-frequency efficiency.

For this reason, the top plate includes an oval cutout positioned to keep the port completely unobstructed.

The tilt angle does not interfere with port operation, as the clearance remains sufficient for proper airflow.

Alternative Top Plate – Closed Version

This variant replaces the original oval port opening with a structurally closed top plate.

Instead of recessed pockets, raised collars laterally guide the original rubber feet. The speaker continues to rest entirely on its factory feet, preserving the exact distance between the bass reflex port and the supporting surface.

As a result, the acoustic behavior remains unchanged compared to placing the speaker directly on a desk. The closed surface increases rigidity and provides a cleaner visual appearance while maintaining the original port geometry.

A small relief groove beneath the port area adds airflow tolerance without affecting tuning.

This version offers a visually cleaner and mechanically simplified solution while fully respecting the original acoustic design of the speaker.