Manequin head wall mount / Pup Hood holder *Woof Woof*
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Tweaked the original design to work with the Styrofoam mannequin heads I got at Michael's (our local craft supply store)
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 20
- Makes
- 0
- Views
- 466
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Cosplay & Costumes in general
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I wanted to mount my new pup hood from Scrapyard Leather, so it would be safe from my clumsy self. The original model looked fantastic, but didnt fit the mannequin heads I was able to get, so I tweaked it, and made it a bit stronger.
To assemble, use 2 m3 heat set inserts in the head shaft, and m3 screws through the support arm, you shouldn't need to glue the shaft into the head, but I used hot glue because why not.
Attach the arm to your wall before screwing the shaft/head to the arm. You probably want to hit a stud or use wall anchors or other fastening as required by local building standards, as just a screw into drywall wont work.
I printed in plain black abs, and its held up fine, though I am very careful with it, I did thicken the part against the wall before uploading as it seemed too thin. I would recommend a stiffer material if possible, abs is quite flexible, either CF reinforced, or something similar.
Also, I'd definitely recommend the 'male' mannequin heads over the 'female' one, as its significantly larger, and held my hood way more reliably.