X-axis belt tensioner for Anycubic Kobra Max
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This design reuses the parts that came with the Anycubic Kobra Max x-axis tensioner. No need to buy anything!
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 26
- Makes
- 0
- Views
- 159
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Anycubic Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a replacement of the x-axis tensioner for the Anycubic Kobra Max, and utilizes parts from that. I made it as the original x-axis tensioner broke, and wanted a more sturdy design anyway.
Start with loosening the belt from the main printhead carriage. Unscrew the x-axis tensioner (two 3mm bolts) and loosen the plastic Pulley Wheel from your Kobra Max. It comes loose if you push out its axle (with a small screwdriver or alike). When the axle and wheel are free, carefully loosen the two silicone gaskets from the axle openings. They can be a little difficult to see since they are the same color as the surrounding plastic (black).
After 3D printing the parts (with your spare printer if your Kobra Max is broken), insert the two tiny gaskets into the holes at the side of the main_bolt_mod. Then set the Pulley Wheel into the main_bolt_mod, and push the axle through one of the gaskets, through the center of the Pulley Wheel and through the other gasket. It should then be firmly set and (almost) rotating freely.
Put the main_bolt_mod into the main_cylinder_mod and screw on the nut. There is only one way it will fit. Mount and screw the whole thing onto the x-axis beam using the two 3mm bolts that held the original x-axis tensioner to the frame.
The last step is to push the belt through your new x-axis tensioner and fasten it to the x-axis carriage. Tighten the belt by screwing the nut clockwise. Your'e all set to go!