1 / 2
WhamBam Mutant v2 BMG Fan Mount
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I remixed the fan mount to get the fan duct into just the right position for a E3D V6 setup.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 9
- Makes
- 0
- Views
- 143
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution
I remixed the fan mount to get the fan duct into just the right position for a E3D V6 setup.
The original model was a little offset and not low enough. My 12v setup struggles with heating if the fan duct hits the heater block at all so I lowered it as well.
Total offset: 4mm left (-4mm x). 1mm down (-1mm z).
Supports are required for the small portion the shroud connects to.
Post Processing
You might also need to make a small cut on the fan since the mounting screw for the brace and the fan are so close on the top.