1 / 6

2 in 1 Photo frame for 4"x6"

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

You can use inner frame alone or in combination with the main frame. It can be magnetized, wall-mounted or supported.

Updated at source: Feb 21, 2026

Model information

The parts are:

Test parts are:

Design overview:

The inner frame holds the photo. It can be tricky to put in the photo in so be careful. The inner frame tolerances are slightly smaller than the photo.
The main frame is compatible with the inner. There is a protrusion that fits into the support cavities. A neodyme magnet (3mm x 12mm) can be inserted after the printing. You can test it first with the test part.
The support has 3 legs. It must be inserted carefully, as the lip feature is thin. Ensure all three legs are properly pushed while mounting. Otherwise a lever force may break the lip.

Precaution for printing:

Bridge parameters need to be properly adjusted to ensure a good fit for the magnet and the support. I suggest testing it before you print the final pieces. For example: brigde speed 10 mm/s, Bridge fan speed at 100%.
Be careful while mounting the support because the lip cavity is thin.
Use 5 walls because the frame protrusion is small. Otherwise it may break if there is not enough material.
Wrapping can occur on the main frame due to its dimensions. I suggest using a brim.
With this in mind, they are easy prints. I used PLA with wood fiber for the aesthetics.

I hope you will enjoy!