1 / 7
Eyeglass Case / Brillenetui / l'étui à lunettes (no supports, w/ FreeCAD design) — image 1
1 / 7

Eyeglass Case / Brillenetui / l'étui à lunettes (no supports, w/ FreeCAD design)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A case for your eyeglasses, does not need print supports, FreeCAD design included

Rating
5 / 5
Likes
4
Downloads
38
Makes
1
Views
191
Reviews
1

Updated at source:

Model information

License
Creative Commons — Attribution — Share Alike

This is a case for your eyeglasses - it should fit most sizes up to a width of about 150mm.

Printing

It prints without supports on a FDM printer - simply put it with the large flat surface down (original orientation of the STL). No special infill settings are needed.

The design is made for a (first) layer height of 0.2mm - the connection at the hinge and at the two bending segments of the lid have exactly this thickness to give you exactly one (bendable) layer. If you use a different layer height the connection may be more stiff (if it results in multiple layers) or not as well connected (partial layer). Inspect your GCode before you print if you use a different layer height.

PLA should be fine for most cases. If you tend to leave your glasses in the sun you may want to print it in white and may want to upgrade to PETG or another filament that is more heat resistent.

Post-Processing

I would recommend to line the case with foam rubber or another soft material (felt, velvet), so that the glasses do not get scratched.

Bend the lid and test the locking mechanism before you glue stuff in.

I myself used thin sheets of self-adhesive foam rubber. You can get 2mm thick self-adhesive sheets relatively cheap online. Or you can use whatever soft material you have got at home and glue it in.

I lined the main compartment with a piece of 155×95mm - starting at the top and carefully pushing it in with a folding knife. I cut the excess material at the hinge using a metal ruler and a cutter knife. I also trimmed a bit at the top to make space for the locking mechanism of the lid.

The lid got lined with a piece of 150×80mm (155mm minus a few mm for the sides, see below), starting at the lock, again trimming excess at the hinge.

The sides of the main compartment each got a 30×60mm piece that got trimmed at the curved edge. This is not strictly necessary, since the glasses cannot face the sides, but it looks better.

FreeCAD Design

The FreeCAD 1.0 design file is included if you want to change anything. Features are named to make it easier to navigate. It uses the Part Design workbench.

If you just want to extend the length of the case - simply change the "Pad Base Shape" Length property.

If you want to change the height or depth of the case - these are in the "Sketch Base Shape" and you may have to experiment with your settings, since the results are not 100% predictable after printing. There are plenty of Reference measurements in this sketch to give you some hints: the length constraints of the lid and the main body side (where the lid rests after folding it) need to be similar; the angles at the hinge need to be close enough to not cause blockage.

Tags