Greenhouse

Original Reddit Post

IMPORTANT NOTES

1. If you have a large enough print bed to scale all the models up to 115%, I'd highly recommend doing so, since the pillar details don't print at the scale at 100%. Everything is designed to fit on the Ender 3 build plate.
2. You'll likely need to sand the surfaces between each part, otherwise you'll end up with a model that doesn't entirely fit together due to the layer ridges. 
3. Please check that the parts fit together cleanly before gluing, so you can get a good feel for how to best assemble the model and also make some small adjustments with sanding.
4. The model is designed to have a ring of fairy lights underneath the platform which get fed through a hole in one of the pillars.
5. If your printer has issues with stringing, then expect a lot of stringing to occur. Mess around with different filaments to find one which produces the least amount of stringing.
6. I haven't laid out the parts for maximum parts per print, so you may want to combine some of the prints.
7. You'll probably want a strong glue for this, ideally 2-part epoxy glue.
8. The Full Model stl is just for preview, and should not be printed.

Instructions

• 1x fountain (glue together and fit into center hole of bottom platform
• 2x bottom platform (unnecessary if you don't want a platform for the greenhouse to sit on)
• 2x front wall
• 2x roof
• 4x cross beam (they fit into holes on the tops of the walls)
• 4x roof beam (they also fit into holes on the tops of the walls)
• print 1x everything else (pots/benches/trees are optional
• If you are printing any of the trees, you will need to print them on a raft. They will cause stringing, and they will most likely fail. Scale them up for better results.

Good Luck!