Glasses holder for 3m 6000 Series Respirator
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
These parts allow glasses with arms removed to be secured inside a 3m 6000 series full face respirator
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 83
- Makes
- 1
- Views
- 295
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Open Community License v1
First things first: THIS IS A PROTOTYPE. This model has not been tested to any safety standards. Please perform individual testing and validation on these parts before considering their use! Remember - these parts go next to your eyes! Do not take that lightly - printing this part out of PLA or some other shatter-able material poses an immense danger to your face and eyes.
The crossbar is held into place under tension by keying into integral features of the respirator. Glasses are held to the crossbar with a zip tie, and the nose bridge adapter provides angle correction and fixes the glasses in place more securely.
The nose bridge adapter should be printed in TPU - 95a or softer. Light on the infill and perimeters. The flex here helps secure the glasses in place. You could theoretically try printing this in PETG, though I think performance would be worse.
The crossbar should be printed in PETG or another material that allows for flex without shattering. My best results were 0.2 layer height, 25% gyroid infill, 4 perimeters, 4 or 5 layers top & bottom.
Crossbar may benefit from a tiny amount of supports on the front end.
Full instruction sheet provided in the photos section of this model
Changelog:
2.23.2026 - Crossbar V1.1 reduces the thickness of the main bar from 3mm to 2mm to allow for greater flex and reduce risk of shattering. V1 file provided in archive folder for reference.
Shoutout to Matt for creating the model below, which served as key inspiration for the tensioned design & use of mini zip ties in my model!