Lightsaber RP2040 Upgraded Blade Holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
An upgraded blade holder for the Lightsaber RP2040. Allows for a better fit.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 22
- Makes
- 0
- Views
- 86
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Props
- License
- Creative Commons — Attribution — Share Alike
The original blade holder on the Lightsaber RP2040 had two main issues:
It was too long and didn't allow the emitter to screw down the entire way.
It was slightly too loose for the Ultrasaber blade I was using.
This remixed design fixes both issues. The length of the holder has been reduced, allowing the emitter to screw down completely. The bottom has also been extended, at a smaller diameter, to slot into the hilt itself for greater stability.
Ridges have been added to the inside and outside of the holder (top and bottom respectively) to improve the grip of the blade itself and to the hilt. The finished result should allow for the holder (and blade) to be inserted with a snug and secure hold, but without either being stuck too tight to remove.