IKEA BERGSBO KALERUM Hole Jig
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This jig helps locate and mark where to drill holes in your IKEA BERGSBO wardrobe doors, to fit KALERUM handles.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 13
- Makes
- 0
- Views
- 125
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Home Decor
- License
- Creative Commons — Attribution
About
These jigs help locate the holes to perfectly center the door handles. If you are fitting many handles, this jig saves a lot of time!
The jig is two-sided: flip it over to get the opposite hole location (see pictures).
Note: I changed the text on the STLs to reference the C2C hole distance, which is more logical for the jig. Always trust, but verify, by measuring the hole marking distance before you drill them!
IKEA Parts
Here are the IKEA parts for reference, at the time of writing:
BERGSBO There are two sizes of door: 50x229cm and 50x195cm. These were designed to center the handles in one of the 50x229cm door panels. The size of the recessed square panel is 362mm, and is used as a reference by the jig. The vertical wood where you will mount the handle is 80mm wide, and the handle is centered on this.
KALERUM There are three handle sizes: 138mm, 266mm, and 394mm. The center-to-center (C2C) of the mounting holes is exactly 10mm shorter than the handle size for each handle. Therefore, choose the jig that is 128mm, 256mm, or 384mm C2C in size appropriately for what you are installing.
Printing
No supports are required if you put the appropriate side on the print plate.
I used PETG (and ran out of orange, so switched to black), and it worked very well. Any sturdy material should work well.
Made With
OpenSCAD and Python