1 / 12
K1C K1 Camera blower fan clip (15 min print and heat problem GONE) — image 1
1 / 12

K1C K1 Camera blower fan clip (15 min print and heat problem GONE)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A simple clip to house a 20x20mm blower fan

Rating
0 / 5
Likes
7
Downloads
25
Makes
0
Views
218
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

As with most people that have done high temp filaments in the k1c and K1 printers, when I got above 40ish degrees for 20-30 minutes the camera would cut out. 

I had a 20x20mm blower fan so I wanted to test if that would help while I waited for a heat sink. So I made a very simple clip. 

After sticking it in and making a USB cable to reach the front of the printer I started some ASA/ABS prints.

Print temps go well above 50+ degrees in the chamber and the camera worked throughout the prints. Longest print so far has been 10+ hours. 

A simple step down buck converter from 24 to 5v will allow it to be connected to the same cable as the LED lights to neaten things up. At this stage I dont think I will add the heat sink as it is yet to cutout. If is does I will add and update. 

I printed it in ABS at very low speed with 0.16 layer height and it takes around 15 min.

Link to 5v Blower Fan

https://www.aliexpress.com/item/1005004770661164.html?spm=a2g0o.order_list.order_list_main.30.2ddf1802JPytSJ

Thanks to @Henlor for the camera model to mock it up on. 

Hope it helps someone.

Happy printing 

        UPDATE FOR INTEREST SAKE:

        After about 20+ prints the camera has stayed during the print without issue.

        I did however forget to plug it in on one print (Have not had a chance to wire it to my LED or Camera              power yet) and as usual it went blank after about an hour. I thought I would try and plug it in to see if            the camera would come back online but it didn't. 

        So the blower is good enough to keep it cool but not enough to cool it down after the fact. Might be              worth while adding a heat sink it this worries you. I think once its hard wired in there will be no need              though as it will come on when the printer does.

        One of these should work nicely. I used the first one. 
        

or 



Tags