Warp-Weighted Tablet-Weaving Loom V2
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
An improved version of https://www.printables.com/model/1267375-warp-weighted-tablet-weaving-loom-v1
- Rating
- 0 / 5
- Likes
- 30
- Downloads
- 70
- Makes
- 1
- Views
- 606
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
A somewhat-improved version of my earlier 3d-printed tablet-weaving loom: smaller, less blocky, packs flat, and doesn't require external clamps.
Notes:
Print 1 of each piece, with the exception of knurledScrew (4 pieces), support (4 pieces) and backClamp (2 pieces)
The supports clip on to the clamp pieces to distribute pressure a little better. It needs a fair bit of force to get them on.
ComfyGear goes on the right-hand side of the shaft (shaft pieces marked with "R"). It's reverse-threaded so that turning the shaft towards you won't loosen the screw.
The clamps are not particularly strong - don't overtighten or you risk cracking them! They really don't need to be super-tight in the first place.
Suggestions for improvement:
The pawl shaft isn't very sturdy and might need to be thicker.
The curved arm that supports the pawl gets in the way a bit when weaving very close to the shaft. It would probably be better if that arm were on the side closer to the user instead.