Apple Watch Stand
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€4.56 – €5.58 net (excluding VAT)
For file: Watch Stand v2.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €5.07 excluding VAT (range midpoint).
- Weight reported by the author
- 44 g
- Print time reported by the author
- 6 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
This is a stand for Apple Watch which a charging cable can be inserted for charging.
- Rating
- 4.9 / 5
- Likes
- 60
- Downloads
- 606
- Makes
- 13
- Views
- 2,678
- Reviews
- 10
Updated at source:
Model information
- Source
- Printables
- Category
- Portable Devices
- License
- Creative Commons — Attribution — Noncommercial
From time to time, my Apple Watch was knocked off the charging cable by accident causing it not completing charging. It was quite annoying as the watch would be left useless without charge. Hence, an Apple Watch stand is needed.
Two versions of stands were made, one taller and one shorter. After printing, the charging cable can be inserted into the stand making the stand capable for charging the watch.
A sample gcode slicing in 0.16mm layer height is also attached for easy reference.
(Edited on 17 June 2022)
As the charging cable for the watch is quite tough, there are chances that the stand may be knocked over by the cable. Hence, a new version (i.e. version 7) is developed. A bottom was added. The cable will be force to turn 90 degrees instead of straight to the bottom. Therefore, flipping over will be avoided.
Also, the size of the installation hole for the charging “puck” may be adjusted by using the scale function of the slicing software. If a smaller hole is preferred, i.e. a tighter fit for the charging “puck”, users may reduce the size of the print to around 99%.