1 / 1
Humminbird Helix Fish Finder Shuttle Glow Cup — image 1

Humminbird Helix Fish Finder Shuttle Glow Cup

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

This is a custom UV LED Glow Cup for the Helix Humminbird fish finder shuttle that allows you to charge your UV lures.

Rating
0 / 5
Likes
4
Downloads
9
Makes
0
Views
133
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial

This is a glow cup and glow cup lid meant to be mounted to the Humminbird Helix shuttle for their fish finders like the Helix 5 or Helix 7. This glow cup is motion activated and allows you to charge your UV jigs or lures when dropped in to the top. The glow cup lid just friction fits to the top, fairly snug but can be removed quite easily as well. It mounts to any of the 1/4"-20 mount points on the base of the shuttle. I used the one on the back left as that is where it is easiest to feed accessory power from inside the battery compartment. This design is fairly specific to the parts I used to create it, so I will include a parts list below. Most UV LED strips will be DC powered, so I did have to cut off one of the SAE connectors that the shuttle ships with and wire in a DC barrel plug adapter. I use a step-down converter to 12v to power my finder and this glow cup with DeWalt 20v batteries, and everything in the parts list below is 12v so your power source must be as well if you want to use that list. Print the glow cup with the bottom on the bed without supports, print the lid with the bottom on the bed with supports.

There are a few changes I would make if I were to have to print it again, including making the exterior walls slightly thicker, as the channel that I cut in to the interior wall for the LED strip goes a little too far in to the wall at the size that it is, you can see some tiny holes in the wall as a result in the video. Does not affect performance but could be improved. I would also probably move the hole that is meant for the 1/4"-20 mounting screw to better align the hole in the wall for the cabling to come out of to be closer to where it goes in to the battery compartment on the shuttle, just for a cleaner appearance. I would probably also better design the cutout in the bottom where the motion sensor goes to make it a snug-fit friction fit. As it is it just rests in that spot and should be held down with some form of double sided tape or command strips.

Parts list:

DC 6V 12V-24V 5A PIR Motion Activated Body Sensor Switch with DC Cable for LED Strip Light (Rectangle(Without Light Sensor), Black)
https://a.co/d/058zF66z

2 Male + 2 Female 12 V 2.1x5.5mm DC Power Jack Plug Adapter Barrel Connector for CCTV Security Camera LED Strip
https://a.co/d/0dFujFYP

LED UV Black Light Strip Kit, 16.4FT/5M Ultraviolet Waterproof IP65 3528 300LEDs, 395nm-405nm Blacklight for DJ Bar Club Party Decor Night Fishing with 12V Power Supply
https://a.co/d/010qDYkI

1/4"-20 stainless steel screw x1

This isn't a part per-se but just a reference so that you know what shuttle it was designed for:
Humminbird ICE Helix 7 Chirp GPS G4 Kit without Battery Fish Finder
https://www.scheels.com/p/08232406215

Tags