Box for reciprocating sawblades. Fixed the shortcomings of the original model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
The filament holes are optimized for 3D printing. The compartments are also in the lid so that the sawblades do not mix
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 25
- Makes
- 0
- Views
- 114
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a model optimized for 3D printing, 245 and 205 mm sawblade compartments, the depth has been increased by 5 mm to store tall sawblades
For greater durability of the hinges and latch attachment in the slicer, you can add modifiers with a 100% fill setting in these areas, as in the photo. 6 solid layers of bottom, 5 layers of top, 15% infill. The latch is very tight, it is better to print it from TPU A95 with 100% filling
----------------------------------------------------------------------------------------------------------------
Это оптимизированная для 3д печати модель, отсеки для пилок 245 и 205 мм, глубина увеличена на 5 мм для хранения высоких пилок.
Для большей прочности петель и крепления защелки в слайсере можно добавить модификаторы с настройкой 100% заполнения в этих областях, как на фото. 6 слоёв дна, 5 слоёв крышки, заполнение 15%. Защелка получается очень тугая, лучше распечатать её из TPU A95 со 100% заполнением.