1 / 3
NVMe fan for Machinist X99 E5-MR9A Pro — image 1
1 / 3

NVMe fan for Machinist X99 E5-MR9A Pro

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Allows for a dedicated 40x20mm fan to add airflow over the dual NVMe slots on the Machinist X99 E5-MR9A Pro motherboard.

Rating
0 / 5
Likes
1
Downloads
7
Makes
0
Views
89
Reviews
0

Updated at source:

Model information

Category
Computers
License
Creative Commons — Attribution

The purpose of this project is to increase airflow and lower the temperature of the NVMe slots on the Machinist X99 E5-MR9A Pro motherboard by adding a dedicated fan. Before utilizing this solution, average NVMe temperatures of 60 °C were observed. Afterwards, temperatures were in the 45-50 °C range.

This project adds a mounting plate that spans over a chipset heatsink, utilizing two of the motherboard mounting holes. There are two versions of the mounting plate: one with a 20mm offset and another with a 30mm offset. Use whichever works better in your situation. A 40x20mm fan is bolted to the fan mount. 5x3mm neodymium magnets are used to attach the fan mount to the mounting plate.

BOM:
  • (8x) 5x3mm neodymium magnets

  • (2x) 20mm (3/4") motherboard mounting screws (either M3 or #6-32, depending on your case standoffs)

  • (1x) 40x20mm fan (designed and tested with Noctua NF-A4x20 FLX)

  • (4x) M3x10mm bolts and nuts (or other hardware to secure the fan to the fan mount)

Instructions:
  1. Print the parts. Recommended: 0.2mm layer height, 3 walls, 3 top/bottom layers. Supports should not be necessary.

  2. The magnets should be pressed into place by hand. Make sure the polarities are respected. If needed, use CA glue.

  3. Remove the two motherboard mounting screws where the mounting plate will be installed. Refer to the photos.

  4. Attach the mounting plate using the longer screws.

  5. Attach the fan to the fan mount using M3 screws and nuts or other mounting hardware.

  6. Place the fan mount onto the mounting plate, and the magnets should hold everything securely.

  7. Wire the fan.

Note: A fan grill to cover the exposed fan blades is recommended. Something like: