1 / 1
Prusa Core One L – Purge Bin + Reinforced Nozzle Wiper (Complete Redesign Remix) — image 1

Prusa Core One L – Purge Bin + Reinforced Nozzle Wiper (Complete Redesign Remix)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Optimized purge bin / trash tray and reinforced nozzle wiper for the Prusa Core One L. Improved fit, increased strength,

Rating
4.2 / 5
Likes
31
Downloads
190
Makes
5
Views
897
Reviews
5

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

This package contains a fully redesigned purge bin (trash tray) and reinforced nozzle wiper for the Prusa Core One L. Although inspired by existing community models, this is not a minor modification but a complete rebuild from scratch. No original STL meshes were reused. The geometry was newly engineered using dimensional references and overall mounting logic from the original designs, but structurally optimized for improved strength, durability, and fit.

Design Goals and Improvements
The redesign focuses on functional reliability under real-world conditions. The purge bin features recalculated wall thickness, increased structural rigidity, improved impact resistance during purge cycles, optimized internal volume distribution, and reduced stress concentrations. The nozzle wiper includes a reinforced base, strengthened wipe contact zones, improved resistance to repetitive high-speed wiping, and optimized tolerances for consistent mounting on the Core One L. Together, both parts reduce flex under load and provide better long-term stability, especially in high-speed workflows.

Material Recommendations and Heatbed Considerations
The nozzle wiper sits close to the heated bed. At bed temperatures of 90–110°C, PETG is strongly recommended for balanced heat resistance and toughness; ASA is ideal for enclosed setups or sustained higher temperatures. PLA should only be used for the trash bin if at all. When printing PETG, ensure proper bed adhesion and moderate cooling for bridges. The geometry of this redesign was optimized with PETG durability in mind.
I successfully used a 0.6 mm High Flow nozzle (E3D HF / ObXidian), with "default" slicer settings and a 0.32mm balanced layer hight.