Cover for large capacitor Ø51 mm
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Cover to make capacitors less likely to be touched when servicing. fits a Ø51x100mm capacitor with screw terminals.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 4
- Makes
- 0
- Views
- 28
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
If your electronics project contains large capacitors they might be the only element that has uninsulated terminals that are easily touchable when servicing. This cap give the terminals some protection that is not an unsightly and annoying to maintain mess of tape and shrink tubing.
It fits capacitors such as this one:
https://www.tme.eu/se/en/details/gt2a229m51100sb/screw-terminal-and-others-el-capacitors/samwha/
They click into the recess near the top of the capacitor and there is a track to add zip ties if you want to secure it even better.
each terminal has space for 3 wire directions going out.
it's got some fancy decoration on top too to make it easier to figure out which way it goes on.
Designed to be printed on the angled top surface "slanted", so the layer lines don't end up along the "fins"
I printed in PETG and had enough bed adhesion without any support, but it's not a huge area on the bottom so a brim might be useful