1 / 34
Mini German 3-Port Deep-Tone Siren Tieftonsirene — image 1
1 / 34

Mini German 3-Port Deep-Tone Siren Tieftonsirene

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A 3D-printable miniature siren based on the historic deep-tone fire sirens from Germany

Rating
5 / 5
Likes
8
Downloads
77
Makes
0
Views
391
Reviews
3

Updated at source:

Model information

Category
Other Ideas
License
Creative Commons — Attribution — Noncommercial

I've kept you all waiting long enough, the files for my 3-port siren are finally here!

I've released 3 designs. The first is the original design which I've printed (with an optimized stator mount), the second is a newer version with some changes, and the third is an eyeballed model of an Elektror S4A. I was originally planning on releasing the models with multiple hole sizes in similar fashion to nascarsimracing1's older releases, but I figure I'd rather get these out first and make changes later. Each set contains one rotor and one stator, and the original also contains a version of the stator with chamfered edges to the ports.

These are made for use with Samsung, Maytag, and Oh Sung microwave exhaust fan motors with an 8mm diameter shaft. The original version was designed with a D-shaped hole 7.9502 mm in diameter, based around measurements of my Oh Sung OBB-2275X1, while the rest were designed with open holes 8mm across. The newer two models have not been print tested, and I have no guarantee that they will work without some creativity.

The parts can be printed with whatever infill suits you best, I used 20% cubic infill, but ideally the rotors would work best at 100% for the longest wind down. The clearances are questionable, so surfaces will likely need some sanding and holes might need drilling out if the fit is too tight. The stator bolts to the motor using the original screws, the rotor slides onto the shaft with a friction fit (possibly assisted with some tape to widen the shaft), and the siren stands with either someone else's stand or the original fan (which doubles as a cooling fan).

A few notes about the original design: I've already posted about the original design's unintended backwards directionality, but it will function when spinning in either direction. The rotor's diameter is a little wider than what these motors can get to full speed, so it will be a little low-pitched running in "reverse". My personal print came out with some defects and mistakes from my cheap printer and poor design on my part, but the design mistakes have been fixed for this release. I had to drill new holes in the stator and drill out the hole in the rotor, as well as use a thin strip of tape on the motor shaft to prevent the loose-fitting rotor from falling and scraping on the floor of the stator.

If you have any questions or comments, please respond! I will reply eventually but please have patience.

Tags