Angled bookshelf speaker stand
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Remix of another speaker stand to make dimensions smaller
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 13
- Makes
- 0
- Views
- 104
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Audio
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This speaker stand angles at 18 degrees and accommodates speakers of approximately 120mm x 110mm (I made it to fit these Ohayo speakers (non-affiliate link) that I purchased). It's the almost the same thing as 3DLayerMaker's model, just adjusted to be smaller, and the honeycomb pattern is slightly different. Pretty new to 3D modeling, so apologies if you have any issues with the model, though I don't think you will.
Printed in PLA, no supports needed, 3 walls, ~15% infill (gyroid, cubic, grid or honeycomb ideally for added strength, though shouldn't matter much if your speakers aren't heavy), 0.2mm layer height, 0.4mm nozzle. Apologies for the terrible picture.