1 / 2
Chitu E1 Box - P4-M6 and P4-M10 PTFE Connector — image 1
1 / 2

Chitu E1 Box - P4-M6 and P4-M10 PTFE Connector

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Connect PTFE tubes to your Chitu E1 using proper M6 or M10 fittings/flanges. No more slipped out PTFE tubes!

Rating
5 / 5
Likes
14
Downloads
97
Makes
2
Views
379
Reviews
1

Updated at source:

Model information

Category
Accessories
License
Creative Commons — Attribution — Noncommercial

Also have a look at my v2 of this model: 


When printing out of the Chitu E1 box you probably experienced that the PTFE tube is pulled out mid-print. This model allows you to add proper fittings/flanges to connect PTFE tubes. There are two versions: For M6 fitting and for M10 fitting. You can buy the fitting on AliExpress and similar stores. This model works for fitting with 1mm pitch.

Variant M6 (for one box):

  • 2x Chitu-Bolt (no support needed)

  • 2x Chitu-M6-Nut (this version requires support in the center)

Variant M10 (for one box):

  • 2x Chitu-Bolt (no support needed)

  • 2x Chitu-M10-Nut (no support needed)

For the bolt you can choose between angled or vertical print (personal preference).

I recommend printing it in PETG at a low layer height (i.e. 0.15mm or less). Print the model in the orientation in the file.

Difference between v1 and v2 is the diameter of the filament hole in the screw (4mm in v1; 5mm in v2). For me the original version has been too tight to get a PTFE tube into the box. Since the tube position is fixed by the fitting there is no need to design this tight.

From https://makerworld.com/de/models/2223150-chitu-e1-ptfe-connectorm6m10 by user_908227022.

Tags