Artillery Sidwinder X4 with BTT SKR Pico
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Adapter and instructions to pair an SKR Pico to Sidewinder X4 Pro/Plus board
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 11
- Makes
- 0
- Views
- 133
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
Artillery Sidewinder X4 Pro/Plus has a custom version of the Makerbase SKIPR Mini that has not strong protections from short circuit, expecially if you work on tool head with printer switched on.
If a short occurs often only the MCU part of the board brakes but the HOST part with RK3328 CPU still works with the USB ports and WiFi.
If so, you don't need to buy a new original mainboard and you can save money pairing the mainboard with a BTT SKR Pico card that has same TMC2209 drivers.
Anyway you can also change the whole mainboard with the Pico + SBC you prefer.
Here the support to put the SKR Pico on top of the stock mainboard, put also the shims under the Pico. Print support in PETG/ABS/ASA and the shims in TPU. The support uses the M3 stock screws but Pico needs 4x M2.5 screws.
Connections are quite plug'n'play, mess with cables cutting the zipties and routing better all them expecially the extruder's motor cable.
Minor hassles: the Pico has 3 fan ports, and on X4 we have 3 fans and a top lightbar with same fan's plug, it's possible to do an Y plug to put hotend and case fan together on FAN1, FAN2 the blower, and FAN3 for Lightbar.
The Probe works putting on VCC and NPN the Pico. It already has cable's pins in the same configuration.
We can use USB to connect the Pico and the mainboard has a free USB port thru a PH2.0 header for a male 4 pole plug, just change the poles position to match what is written on the mainboard 5V, GND, D+, D-. Use a needle to remove pins from plug and change position.
Hardware:
4x M2.5x8
1x PH2.0 4P to USB-A male adapter
1x USB-A female to USB-C adapter
Or a Male PH2.0 4P header with 10 cm cables and cut an USB-C data cable to solder with PH2.0 cable.
A printer.cfg example is provided, check files section.
