Capra Audio Cup Holders for Audio-Technica ATH-A700 Headphones
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Capra Audio Cup Holders for Audio-Technica ATH-A700 Headphones, uses original drivers and closed back housing.
- Rating
- 5 / 5
- Likes
- 2
- Downloads
- 4
- Makes
- 1
- Views
- 90
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Music
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I love my Audio-Technica ATH-A700, but it's on its last legs, the plastic was basically disintegrating, but the drivers and closed back housing are still in good condition. I remixed the cup holders from the “Audio Technia Capra Headband Conversion” to fit the drivers and closed back housing. Follow the same instructions from "Audio Technia Capra Headband Conversion". This modification requires a soldering iron.
BOM
2x (adjustment-arm.stl + pivot-block.stl) or adjustment-armstatic.stl from "Capra Headband V3"
1x comfort-strap-capra-headband-v3.stl from "Capra Headband V3"
1x Any of the TPU-Bands, I used the tpu-band-smooth.stl from "Capra Headband V3"
1x yoke-l.stl (below) or from "Audio Technia Capra Headband Conversion"
1x yoke-r.stl (below), this is mirrored from yoke-l.stl
1x Left Cup Holder from this model
1x Right Cup Holder from this model
Original closed back housings from Audio-Technica ATH-A700 from both sides
Original drivers from Audio-Technica ATH-A700 from both sides
Original earpads or aftermarket from Audio-Technica ATH-A700
M3 Heat-set inserts
M3 FHSC Screws
3.5mm Connectors
Wires
3.5mm dual entry headphone cable