Wall-mounted Siva Logo Lamp

This wall mounted Siva logo lamp is my contribution to Season of the Plague. For more information on the fan project and a ton of amazing siva themed stuff visit the official Season of the Plague twitter account: https://twitter.com/SeasonThePlague

What you need to make your own lamp:

• A good amount of black filament for the front and back shell
• Some transparent red filament for the diffusor
• One of these battery powered LED strips: https://www.amazon.de/dp/B08FDTF88D/ref=cm_sw_r_tw_dp_Z4M1CTPGGB24K7EFJWCX
• Aluminium foil or reflective tape
• Glue or tape of your choice
• Two (at least) 50mm long Nails with a head diameter of less than 9mm

How to print the parts:

• Diffusor

Rotate the model in your slicer so it is flat against the print surface and print it solid

• Front shell

Rotate so the logo is facing the print surface and print solid as well

• Back shell

Rotate so the holes for the nails are facing the print surface and print with about 10% infill

This model does not need any supports, bridging is your friend here!

Assembly:

• With the glue/tape of your choice stick the diffusor to the back of the front shell
• Stick a good amount of aluminium foil or reflective tape to the top side of the back shell to reflect the light from the LEDs
• Guide the LED strip through the hole in the back shell and stick it to the top side wall in a circle
• Stick the LED strip's battery pack to the wall-facing side of the back shell
• Slide the front shell over the back shell

Notes:

• The holes for the nails are 90mm apart
• When putting the nails into your wall, make sure to let them stick out a bit so you can use the push button on the battery pack to turn the lamp on or off by pressing the whole thing against the wall a little

Print Settings

Printer Brand:

TEVO

Printer:

Rafts:

No

Supports:

Infill:

10

Filament:

Polymaker, Eryone PLA, PETG

Black, Transparent Red

Notes:

Category: 3D Printing