Xshot Micro reshell M2V3 revolver holster
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a set of left and right side belt holsters for the Xshot Micro M2V3 reshell by GenCoMegawerks.
- Rating
- 5 / 5
- Likes
- 13
- Downloads
- 19
- Makes
- 1
- Views
- 401
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Toys
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I printed these at 30% infill and 6 walls. Supports are needed on the build plate for the holster and release lever, and additionally on the model for the lever holder. One rubber band per holster will be needed to allow the lever to do its job of holding the blaster in the holster. The screws are M3 stainless steel machine screws with hex nuts that I got from a kit on amazon. 1-3Mx35mm for the hinge and 2-3Mx18mm to hold the lever holder onto the holster. I may upload a version with the lever holders attached and a printed hinge pin if there is enough interest. The belt loop is sized for an inch and a half belt. Please let me know if there are any modifications that you would be interested in and I'll see if I can do them.