Emoji Faces Cube
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Other Toys & Games
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
To each side of the cube is applied an Emoji face, created using Tinkercad.
The corners and edges of this cube have been rounded to remove sharp edges.
The cube can be used to stamp modelling clay or as printing blocks to apply paint to paper or fabric.
Size: 40(W) x 40(H) x 40(D) mm
Weight: 30g
Print Details
Filament: PLA Orange
Layer Height: 0.12mm
Infill Density: 25%
Infill Pattern: Cubic
Wall count: 4
Base Adhesion: Skirt
Support:
Support is required due to the small contact area of the model (~20 x 20 mm), compared to the full base dimensions of (40 x 40 mm), which results in a overhang due to the rounded edges.
Structure: Normal
Placement: Touching Buildplate
Overhang Angle: 50 Degree
Pattern: Grid
Post processing
This should be minimal but light sanding may be required subject to print quality after removal of the support.