Belt stop, 6mm and 10mm
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Made a simple thing to finish off a belt for my cr10S5 but it should work fine for similar attachment points. CR10…
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 45
- Makes
- 0
- Views
- 289
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
Made a simple thing to finish off a belt for my cr10S5 but it should work fine for similar attachment points.
CR10 ends are crimped, but these are removable and adjustable.
Thread the end of the belt up through the most narrow part with the teeth towards the middle (smooth side towards the emblem). If the belt is hard to thread then chamfer the ends just a smidge.
Fold the belt over and engage the teeth to the teeth and pull it back in to make it tight. Check the fit and adjust if you feel the need. See pictures for threading.
If your printer can not handle the tolerances you can adjust it a bit in the slicer to make it easier or tighter. If it is not tight then it may slip.
Enjoy!
Print Settings
Printer Brand:
Prusa
Printer:
i3 MK2S
Rafts:
No
Supports:
No
Notes:
enough walls to make it basically solid. i used petg for this .
Category: 3D Printer Parts