1 / 4
MC4 Pliers
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
If it doesn't work it's because you're bad and should feel bad.
Need to use filaments that hate each other, I used PETG and PLA.
There are three bodies you need to set to another material, they're the thin ones.
The front two are just premade supports to give it a good finish, feel free to delete and use normal supports.
The centre washer is obviously needed for it to work, it's a zero clearance washer.
Print it, flick the two supports off the front, give it a little squeeze and it should come apart if your printer is calibrated.
Probably on the harder side to print, if your printer isn't tuned and it doesn't work, get good.