Gutter Square Downpipe Diverter Twin Access
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
The design is my take on the "FloPlast RVS1 Rainwater Diverter", that fits 68mm square PVC downpipes.
- Rating
- 0 / 5
- Likes
- 24
- Downloads
- 56
- Makes
- 0
- Views
- 1,084
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Noncommercial
Material Used : PLA+ 2.0
Note : If you notice leaks through the device, then it might need sealing. Not had the issue myself, but you could try spraying the outside and inside with "Clear Lacquer". The same applies to accessories.
Installation :
1. Position the water butt 500mm maximum from the downpipe.
2. If not already fitted, you may need to fit an inlet and outlet water butt kit(s). The outlet must be lower than the inlet fitment.
3. On the downpipe, mark where the bottom of the inlet / outlet hole occurs on the water butt.
4. Mark another line 55mm above the first for the inlet or 55mm below for the outlet from the water butt.
Note : The measurement is a rough idea, so take care and alter according to your square pipe already installed. The downpipe will travel a maximum of 30mm from the top edge, and rise 15mm up from the bottom edge, to ensure water flow is unhindered.
5. Carefully, cut through the downpipe on both lines and then remove the PVC section.
6. Gently lift the pipe and insert the "Gutter Square Downspout Diverter Twin Access", with appropriate accessories already fitted.
Note : Waterflow direction is indicated on the side, as well as a reminder the fitments are for M22 threaded accessories.
7. Apply white / clear sealant to seal the diverter in place.
8. Connect, using correctly sized accessories, the inlet and outlet to the appropriate diverter
Accessories modelling located here :
https://www.printables.com/model/1637485-garden-hose-attachments