Crystal Deodorant Holder — Replacement Base + Screw-On Lid

Why?

If the plastic base on your crystal deodorant has cracked, this is a sturdy PLA replacement rather than buying a whole new product. The crystal lasts for years — the holder should too.

Features

• Screw-thread lid — 1.5-turn thread securely holds the lid in place

• Flush design — base and lid share the same outer diameter for a clean, seamless look

• Internal lip — prevents the crystal from sitting too deep; creates drainage space below

• Drainage holes — 5 holes through the base floor let moisture escape

• Rounded edges — comfortable to hold, with a flat bottom for standing upright

• Fully parametric — everything auto-sizes from the crystal dimensions

• Customizer dropdown — pick your product preset or enter custom measurements

Product Presets (via OpenSCAD Customizer)

Print Settings

• Material: PLA

• Layer height: 0.2mm

• Infill: 20%

• Supports: None needed

• Base: print flat-bottom on bed

• Lid: print with cap on bed (auto-flipped in OpenSCAD when you select part = "lid")

How to Customise

1. Open the .scad file in OpenSCAD

2. Open Window > Customizer

3. Select your product from the dropdown (or choose Custom and enter your crystal's diameter and height)

4. Select part = "base", press F6, export STL

5. Select part = "lid", press F6, export STL

6. Slice and print!

Fit Adjustment

• Thread too tight? Increase thread_clearance (try 0.4)

• Thread too loose? Decrease thread_clearance (try 0.2)

• Crystal too tight? Increase custom_diameter by 0.2mm

• Crystal too loose? Decrease custom_diameter by 0.2mm

Disclaimer

Salt of the Earth is a trademark of Crystal Spring Ltd. This is an independent, unofficial replacement part — not produced by, endorsed by, or affiliated with Crystal Spring Ltd.