Bird/Squirrel Feeder - Picnic Bench
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Small Picnic Bench for all outdoor critters. Perfect Squirrel and Bird Feeder. Fits Smaller Print Beds. No assembly.
- Rating
- 0 / 5
- Likes
- 11
- Downloads
- 22
- Makes
- 0
- Views
- 159
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Squirrel/Bird Feeder - Picnic Bench
Perfect to mount onto a fence or tree. This design has a built-in rim around the table to fill with feed and includes drain slots on one end. The tabletop is at a very slight angle so that water can drain through the drain slots. Groves are built-in to the seats for better grip. Everything is designed to use minimal supports. No assembly required.
Flashforge AD5M(0.4 Nozzle), 220x220x220 print volume, Overture PETG
Print Time= 12hr 20min
Total Filament= 253.92g, 83.12m
Part is printed at an angle in order to fit on print bed, reduce the amount of supports used, and offers increased strength. I have tested and printed multiple PETG and PLA benches in various colors with no failed prints.
Print Instructions
Any settings not stated are left as default.
Layer Height: 0.2mm
Avoid crossing walls, Max detour length: 200mm
Wall printing order: Inner/Outer
Overhangs, Reverse on even: enabled
Wall Loops: 3
Infill: Adaptive Cubic, 6%
Speed: 50mm/s, first layer. 80mm/s, all other layers
Supports Enabled(Supports painted where needed, everything else removed):
Tree
On Build Plate Only
Top Z= 0.28mm
Bottom Z= 0.2mm
Top Interface Spacing= 0.1mm
Tip Diameter= 0.8mm
Branch Density= 20%
Tree Support Branch Angle= 45 degrees
Brim Type: Outer brim only
Brim Width= 7mm
Brim-object gap= 0.1mm