73ft N Scale Lumber Load For Rapido Centerbeam Car
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I found that the original file needed to be shrunk a little to fit the car, here is the file to fit (mine at least).
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 23
- Makes
- 0
- Views
- 144
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Vehicles
- License
- Creative Commons — Attribution
I downloaded the original file from pbechard and noticed that the file for the 73ft load fit the Micro-Trains center beam but not my Rapido. I edited the file to fit the Rapido center beam without any modifications (at least my car). Hopefully it works with yours as well.
Here is the link to the website with the load wraps available:
Read the original description, it tells you more than this, it also has the 61' load for download
Assembly process:
Test fit your printed load on car, lightly sand edges/corners as necessary. The paper will add a bit more width, so keep that in mind.
Cut out the paper logos using the guide, then place the cutout face down on your work surface.
Cover the load cube with your favorite glue on all sides except the side with the hole/words. I used 3M 77 Spray Adhesive. I'm sure glue sticks would work too.
Flip the load cube to be sticky side down, and center in the paper cutout. Press firmly.
Carefully fold the long edges over the block and secure. Repeat on short edges.
Trim any excess paper with a sharp hobby knife.
Optional: I found the loads fit pretty tight as is, but if they are a bit loose you can secure a 6mm x 2mm disc magnet (eBay, Amazon) into the hole on the back, paying attention to polarity so that a matching pair of loads will attract each other when installed onto the car.
