Cat Fishing Rod Toy (Unglued Remix) with M3 bolts
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Added M3 holes for fastening parts
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 15
- Makes
- 0
- Views
- 177
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Pets
- License
- Creative Commons — Attribution — Share Alike
Added holes for an M3 bolt to fasten the WinderBase and ReleaseCover. Length can range from 4 mm to 12 mm.
Used Sufix 832 ice braid as a fishing line because it worked better than paracord and wasn't expensive.
Also added a shroud to use a socket head M3 bolt between the OuterReel and handle to prevent the fishing line from catching on.
Added hole for M3 bolt in the PoleReelMount. Used a 4 mm bolt here. It serves two purposes:
Secure the ReelGuide but keep a bit of wiggle room.
Prevent the fishing pole from sliding off.
The ReelGuide has an inner diameter of 14 mm whereas the PoleReelMount's outer diameter is 13.6 mm. The distance from the inner diameter to the flat on the ReelGuide is 11 mm; on the PoleReelMount, it's 10.6 mm. Hence, the tolerance would be fine enough if they were both fully cylindrical, but since they're D-shaped and printed in different orientations, adding the bolt was necessary to keep the kitties' play time moving forward with one less distraction.