1 / 3
Camlock Adapter for Plunge Saw ( Parkside PTSS 1200, Walter, Güde...) — image 1
1 / 3

Camlock Adapter for Plunge Saw ( Parkside PTSS 1200, Walter, Güde...)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

This part replaces the exhaust port of your budget plunge saw. Fits on Parkside, Walter, Güde and some other cheap saws.

Rating
0 / 5
Likes
2
Downloads
18
Makes
0
Views
108
Reviews
0

Updated at source:

Model information

Category
Tools
License
Creative Commons — Attribution — Noncommercial — Share Alike

Asi i own a Parkside PTSS and switched to the Camlock dust collection system, i wanted to modify my plunge saw so it does not need any separate adaptors that make it bulky and tend to fall off.


Using parts from Peter H's drei-d-w's models, i added the part that goes into the blade shield of the saw in Tinkercad. The part is intendend to replace the original exhaust connector.

Printed it in PLA+ with tree supports and that worked good on my Ender 3 V2 Neo.

To install it, just unscrew the 5 screws marked in the image, take the cover plate off and swap the old to the new part. Always disconnect power cable before working on your tools!

If it's too tight to move it easily, just sand it a bit with 150 grit paper and go through the groove with a small file.

Safety Warning:
Please make sure that there's always an intact plastic part (either the original one or my version) installed on your saw, as it also keeps your fingers from reaching the saw blade inside.

If this worked for you, please give it a like and upload a make.

Please also mention if it worked for another brand or saw model, i will update the tags and description, then.

Tags