60mm Picatinny Rail (M4 Countersink)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a 60mm Picatinny rail designed specifically for airsoft applications.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 20
- Makes
- 0
- Views
- 52
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Sports
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a standard 60mm MIL-STD-1913 Picatinny rail section. It is designed for airsoft use, featuring two mounting holes specifically clearanced for M4 countersink bolts to ensure a flush, snag-free surface for your optics or grips.
Print Settings
To ensure the rail teeth meet the tight tolerances required for accessories, use the following:
Layer Height: 0.1mm – 0.16mm (Critical for accurate "slope" geometry).
Perimeters: 4 minimum (You want the "teeth" and bolt seats to be solid).
Infill: 40% - 100% (Gyroid recommended for impact resistance).
Supports: None required. The 45° undersides are designed to print cleanly.
Material Choice
ASA / ABS: Best for outdoor use and heat resistance. Note that these materials shrink (approx. 0.7%–1.5%); if your rail feels too short or thin, adjust your horizontal expansion in the slicer.
PETG: Excellent toughness and UV resistance. Easier to print than ABS but slightly more prone to "stringing" in the bolt holes.
Avoid PLA: It will soften in a hot car or under direct sunlight, causing your accessories to lose their shape or fall off.
Technical Dimensions
Total Length: 60mm
Slot Width: 5.23mm (Standard)
Hole Type: M4 Countersink (90° head angle)
Warning: This is for Airsoft/Paintball use only. Do not use 3D printed rails on real firearms as the recoil and heat will cause immediate mechanical failure.