Sub Air Cleaner Housing For Honda (17256-MT4-000)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A compact, two-part 3D printable filter. Features a snap-fit lid and requires a simple simple foam insert.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 21
- Makes
- 0
- Views
- 123
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Overview
This is a replacement housing for the Honda Sub Air Cleaner (OEM Part No. 17256-MT4-000). This small but crucial part is found on many Honda motorcycles, most notably the CB600F Hornet (1998–2006), but also on VFR750, CBR600F, and others.
The original plastic casing can become brittle over time, and the tabs often snap during maintenance. This 3D-printable version allows you to restore your secondary air filtration system easily.
Why is this part important?
The sub air cleaner filters the air used for the carburetor atmospheric pressure equalization (the vacuum slides). If the filter inside or the housing itself fails:
Debris can enter the carburetor internals.
Sticky slides can cause poor throttle response or "hanging" RPMs.
The bike may struggle with a smooth idle.
The model consists of two parts:
Main Body: Features the inlet port for the breather hose.
Filter Cap: Secures the internal filtration media.
Assembly Tip
Don't forget to insert a small piece of oil-resistant foam inside the housing before snapping it shut or installing it. Do not run the bike with an empty housing!
Compatibility
Primarily designed for:
Honda CB600F Hornet (PC34/PC36)
Honda CBR600F (F2, F3)
Honda VFR750 / VFR800 (early models)
And any other Honda using part 17256-MT4-000.
Print Instructions
Material: Since this sits near the engine, I strongly recommend using PETG, ASA, or ABS. Standard PLA may soften due to engine heat.
Supports: Enabled tree support. Heatbed only
