Raspberry Pi 2 B+ mounting cage for Top Hat DIN Rail / Cap Rail / Hutschiene 35mm
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a bare holder to mount your Raspberry Pi B+/2 on so it stands level on the table even with mounted heatsink on…
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 110
- Makes
- 0
- Views
- 1,439
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a bare holder to mount your Raspberry Pi B+/2 on so it stands level on the table even with mounted heatsink on the bottom.
You can use my Top Hat Rail / Cap Rail mount base plate to easily mount your Raspberry Pi into your control cabinet.
There are two versions of the holder:
- One with a flat base for simple table stand or for glue to the flat Cap Rail mount base plate
One with clips to snap on the version of my Cap Rail mount that has notches
Thread the holes with M2.6 thread cutter before mounting the Pi on it.Hint: The clips snaps really tight on the notches of the Cap Rail mount. I carefully bent the clips a little bit before putting these two together. You have to use quite a lot force to snap them together. But the PLA I used for printing was flexible enough. Once snapped together it is not designed to be put apart again.
Have fun with it :)
Print instructions
Category: Electronics