Blocks Bunny (Voxel Art Rabbit)

Meet "Blocks-Bunny," a stylized rabbit sculpture inspired by voxel art. With its geometric, blocky aesthetic, it’s the perfect modern decor piece for your desk or shelf.

I remixed this model specifically for the Easter 2026 Flash Contest. With such a popular, recurring theme, it is always a challenge to come up with something fresh that hasn't been seen a hundred times before. My goal was to create a digital, pixel-inspired twist on the classic Easter bunny.

The first attempt at printing used tree supports, but it ended in spaghetti everywhere—maybe the room temperature was too cold. Anyway, I tried it again and it worked. Third time's the charm: I used the 'snug' support setting, thinking they would be easier to remove. I was wrong; it’s a pain. So, if you enjoy a little bit of suffering, you should try it too.

There are two distinct ways to print this model:

1. Standard Print

Print it as-is with your usual settings for a clean, pixelated look.

2. "Make Overhangs Printable" Setting

By enabling this specific setting in your slicer (like PrusaSlicer), you can significantly alter the print process:

• Pros: It can save you about 30% to 40% in total print time because it eleminates the need for support completely.

• Cons: It will change the visual geometry of the blocks on the underside. However, this gives the bunny just a alternative "stepped" look, i like it kinda more that way..

Happy printing :)