1 / 8
Chest Carrier for Yaesu FTM-150R — image 1
1 / 8

Chest Carrier for Yaesu FTM-150R

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Designed to make working FM satellites a little easier.

Rating
0 / 5
Likes
6
Downloads
15
Makes
0
Views
244
Reviews
0

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution — Noncommercial

The Yaesu FTM-150R(ASP) is a pretty good radio for working FM repeater satellites. It is able to do crossband duplex, has good harmonic filtering, and has a good receiver. It is a bit clunky to use with a handheld beam antenna (Arrow or Elk) while also trying to use the mic, record callsigns, and keep track of the satellite with your phone. I designed this simple chest mount to hold the radio, the mic, and a 3Ah battery (Bioenno BLF-1203AB).

STL and STEP files included to make remixing easier if you want to use a different battery or change something. 

If using a handheld antenna, SET THE TRANSMIT POWER TO "LOW." The instructions that came with my Arrow antenna say 10W is the maximum safe power when operating handheld.  FTM-150R can transmit at 50, 25, or 5W. 5W should be plenty. Be safe!

I printed the Chest Plate in PETG and the Mic Mount in PLA (because I ran out of PETG).

If you need a radio chassis mount, I also included a printable version. It prints in two halves, use some CA glue to join. PETG recommended for a tiny bit of flexibility in the friction-fit lock-tab. If you use a printed chassis mount, you may need to use slightly longer M5 screws. Also, you'll use 4 x M5 screws instead of 5. It only has 4 screw holes. Use washers between the nuts and the printed chassis mount to reduce the risk of layer separation. 

Print the Chest Plate flat with the battery compartment facing up.

Print the Mic Mount on its edge with the flat edge down. 

Print the Chassis Mount pieces with the joining faces up. Should look like the letter "U" 

Parts needed:

5 x M5 x 12mm "flat head" screws (for countersunk holes) with washers and nuts (chassis mount) (4 screws 15-16mm long if using printed chassis mount)

2 x M4 x 8mm screws (mic clip)

2 x M4 threaded inserts (mic clip)

Small Velcro strap (battery)

Some straps from a backpack. I found this model to be useful in adapting my straps to this project:

Tags