XY-Clock WiFi / Sinilink Clock

You will need:

1x the clock itself
https://s.click.aliexpress.com/e/_c3QOXIxb
https://s.click.aliexpress.com/e/_c3wPSZcp
https://s.click.aliexpress.com/e/_c2vxBwkV

2x M2.5x 10mm, Countersunk
7x M2.5x 8mm, Countersunk
2x M2.5x 5mm, Countersunk

Hex drive
https://s.click.aliexpress.com/e/_c4kBzxfJ

Torx drive
https://s.click.aliexpress.com/e/_c3qnP3i9

The power supply needed is 5V through USB, an "intelligent" USB-C Charger will not work (no trigger), you will some USB-A to USB-C cable.

1x USB C female Socket
https://s.click.aliexpress.com/e/_c4sbJ8PT
https://s.click.aliexpress.com/e/_c3OADhPf

Assembly:

1. Power it up and configure it according to XY-Clock Sinilink 

2. Solder the USB-connector to the Clock

3. Mount the two L feet to the clock, see picuter (needs to be printed twice...) (2x 8mm)

4. Mount the Clock with the feet to the base (2x 10mm)

5. Mount the top little Clock-holder (1x 8mm)

6. Mount the USB-C to the back plate (2x 5mm)

7. Mount the back plate(4x 8mm)

8. Done

Note:
If you require a real USB-C socket, I'll create a design for you.

Note:
The margins are tight, if something doesn't fit, please let me know, I will adapt it so it fits for you.
I tried with two different Clocks, both worked, but quality might be an issue...

Note:
There is a small battery in the clock - it can be removed, it's useless as the clock with fetch the time from the internet. I did it to prevent it leaking.

= = = =

Option:
If the clock is too bright or you want something in front of the segment display, please use those parts:

in addition to above you will need:
+ 5x M2.5x 8mm, Countersunk
+ Your own filter

Note:
One is flat, one has 0.1mm and the other 0.2mm space. Print what you need
The five screws holding the panel, be VERY careful when tightenig them... I told you...