T100 V1.1.0001
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Upgrades, I created for my T100...
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 3
- Makes
- 0
- Views
- 23
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
Electronics:
I built my T100 with a Raspberry Pi 5 because I already had one. It should also work with a Raspberry Pi 4, 3, or any other board with the same form factor.
The second priority was to move the SKR Pico to the top — it looks too good to be hidden under the Raspberry.
The fan mount should be printed with many perimeter walls (I used 5) to avoid strong vibrations (for such a small fan). It might also be an issue with the cheapest 3010 fan I found on AliExpress.
PSU mount:
The PSU mount was a bit too wobbly for my taste. The PSU part acts as a replacement for the right inner frame connector and also doubles as a cable guide.
Hardware:
2× M3 × 10 mm screws
2× M3 heat-set inserts
30×10 mm fan
Screws to secure the fan — I found some with a 3.4 mm outer diameter*
A bit of extra filament used as pins to secure the inner parts (optional)
*The plastic cracked.
...Is it really stupid when it's stupid, but it works?