YASPO: Yet Another Small Parts Organizer

YASPO: Yet Another Small (and smaller) Parts Organizer.

Another version of the Small Parts Organizer. Why another one? Just because ;)

 I needed a version tailored exactly to my needs, and I’m sharing it here in case someone else might find it useful :) This one has the dimensions I needed, uses minimal filament while offering sufficient strength and functionality.

 I’ve prepared containers in several different versions:

• Single (one large box)

• 2V2H (4 compartments)

• 2H (2 compartments in a horizontal layout)

• 2V (2 compartments in a vertical layout)

• 3H (3 compartments in a horizontal layout)

• 3V (3 compartments in a vertical layout)

Plus, there are also bins for the Gridfinity system designed for 1, 2, 4, 6, or 8 YASPO containers. All Gridfinity bins are 2U wide, with the length depending on capacity (1U, 1U, 2U, 3U, or 4U, respectively).

The lid and bottom section are connected with a piece of filament. You need to slide it in so that the end of the filament shows on the other side but doesn’t stick out, and then snap off the rest. Sometimes you have to press the lid down harder; with two organizers, I had to open the lid, etc., but it’s easy to connect them.

I decided not to print labels, though. It’s a waste of plastic :) I figured it’s better to use a dedicated tool—a label printer. My printer’s tape width is such that I had to use a smaller font and fold the bottom part of the tape. It’s legible, convenient, and works :) (see: photos).

My printer settings:

• PETG

• line height: 0.2

• 2 walls

• 25% infill, gyroid

• no supports, no brim