Fossil Carlyle Watch Stand
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Model information
- Source
- Printables
- Category
- Other Fashion Accessories
- License
- Creative Commons — Attribution
A watch stand charger holder for a Fossil Gen 5 Carlyle, I'm not sure if it works with other smart watches, it uses a 26mm diameter and, 8mm thick charging puck. Wire from the charger is routed through the back and down the spine of the stand.
Placing the cable into the channel takes a bit of force, I used the edge of a card to slot it in; it shouldn't do any damage. After the cable will route out of the channel in the spine of the stand.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
Yes
Resolution:
200
Infill:
20
Filament:
PolyMaker PLA
Notes:
Print on the back side with the cable channel. Depending on how well you can do overhangs supports may be necessary in the recess for the charger.
Category: Accessories