Ø50mm bushing for 6301z bearing
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
The bushing is designed to be printed around a 6301z bearing. You are required to pause the print before your printer…
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 8
- Makes
- 0
- Views
- 137
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution
The bushing is designed to be printed around a 6301z bearing. You are required
to pause the print before your printer begins working on the lip that will
seal in the bearing. This can be done by inserting two lines of code right
after the command to raise the Z axis like so:
G1 X0 Y0 ; move print to a more approachable position
M226 ; Gcode initiated Pause or Wait for pin state in Marlin
If your printer is a Marlin or the firmware is setup as one the M226
command should be omitted in favor of:
G1 X100 F50 ; move the printhead to X100 at 50mm/min
This will give you two minutes to insert the bearing into the cavity.
The "leaves" create an intereference fit which can be adjusted by
changing the parameters in the SolidWorks Part file, In here it is also
possible to change the tolerances of the bearing, diameter of the rod and the
resting lip.
Print Settings
Printer:
Ormerod 2 528.4
Rafts:
Doesn't Matter
Supports:
No
Resolution:
0.2
Infill:
20% honeycomb
Notes:
Filament: Verbatim white PLA 1.75mm
Hotend temperature: 195°C
Heated bed temperature: 55°C
REMEMBER REMEMBER REMEMBER REMEMBER REMEMBER REMEMBER REMEMBER
Place the ball bearing on the heated bed so it comes up to temperature prior to inserting it. If the bearing is cold the extruded filament will curl up.
Post-Printing
After the print is completed insert the bushing into a vise so the inner part cannot move. This helps you in drilling it out to fit whatever size rod you intend to insert. The .STL file is built to support a ~8mm rod.
When done the bushing can be removed from the vise and inserted into the desired roll of filament. The leafs are intended to "give" as the diameter is slightly large than the spool hole, causing an interference fit. This will be a very snug fit.
Category: 3D Printer Accessories