kodak xl330 main drive gear replacement

NOTE!
This is a super small and fine gear. 1x1xa0.5cm approximately. Normal 0.4mm nozzles wont cut it usually. You either need a 0,1-0,2 or a SLS, SLA etc printer that can achieve those resolutions.

Small key-files might be required for a perfect fit. 

Version 2 is available for a better fit as another owner of the camera came forth with pictures of an intact one! Also noticed i was missing 1 tooth of the smaller gear piece.  Thank you @DavidCunning_4774146   for the clear high-res images.

Reverse engineered, main drive gear for the Kodak XL330 8mm film camera

Reddit request, user couldn't find a replacement gear after thrifting this item. Gear exploded upon contact. And i did my best to use scales and pictures to replicate it.

Might need a bit of sanding, filing, and scaling in your slicer. When printed, first try it manually (not with the motor) and then install it. 

Lubricate it a bit, try to use Nylon or ABS. PLA is quite brittle for this.

*Use at your own risk*

Following is the design process in case you need to make other gears, or adjust this.
Step files are included. 
Not for sale! It's a free model!