1 / 2
Kobra 3 v2 Z-Axis Anti Vibration Supports — image 1
1 / 2

Kobra 3 v2 Z-Axis Anti Vibration Supports

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A fully printable anti-vibration solution!

Rating
0 / 5
Likes
8
Downloads
58
Makes
0
Views
319
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

After looking at the parts price of an threaded rod based anti-vibration support, I decided I wanted to try to print an alternative that would hopefully be more rigid as well. The supports tie into the stock back mount screw holes and replace the Z-axis caps entirely, using vertical uprights to tie them together. Each section connects via a taper, and is designed to be super-glued together. The final project uses about $5 of deeplee PLA pro, and four M5x20mm button head screws.

The model is specifically tuned for PLA and the following print settings on a Kobra3v2. The z cap fit and tapers may have dimensional or alignment issues if other print settings are used.

Print Settings--I used the LowRiderV4 advice as a basis:

  • PLA for rigidity (I used deeplee PLA pro)

  • 0.4mm nozzle

  • 0.2mm high quality profile as basis:

    • 4 wall loops

    • Rectilinear top and bottom surface patterns

    • 5 top and bottom shell layers

    • cubic infill pattern at 15%

    • Line width of 133% for all but supports

    • Supports enabled

Assembly required a little sanding on the support surfaces for a complete press fit prior to gluing. Bearings can be transferred from the stock endcaps by using a knife or box cutter to gently pry them out.

 

Tags