Motocompo keychain
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A keychain with the Motocompo logo
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 6
- Makes
- 0
- Views
- 31
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Soo, I saw something shiny on the Internet. A Honda Motocompo, that a guy had imported from Japan. After drooling for a while, I noticed the magnificent logotype. And proceeded to drool some more. OK, I'll probably never own a Motocompo. I would like to have one. But then again, that's what I always say. Have you seen my garage? -me neither, too much stuff to find it anymore.
Well, if I'm not getting the bike, at least I can print the keychain. Well, turns out I probably can't. This should be smaller than I can print this kind of details with the stock 0,4mm nozzle. You should probably use a smaller nozzle and scale this down a bit. And use Arachne. And ironing. Everyone likes ironing.
I printed this on my Bambu Lab X1C, 0,12mm layer height, really slowly. I used AMS for colours, but without a multicolour thingy I would just insert a pause after the last red base layer, then switch to white filament to print the logo, and worry about the orange bits later.
I printed this with the logo on both sides by printing one front, one back and gluing them together. That's why the parts are quite thin.